login   |    register

Scale Modeling Sponsors

See Your Ad Here!

Built a model or part from your own materials lately?
Hosted by Mike Kirchoff
Material for very thin leather straps?
Visit this Community
North Carolina, United States
Joined: January 20, 2005
KitMaker: 702 posts
Model Shipwrights: 0 posts
Posted: Tuesday, April 04, 2017 - 02:30 PM UTC

Painters tape or masking tape. Hit end w/ super glue and it will never drop off.
Visit this Community
Stockholm, Sweden
Joined: November 29, 2006
KitMaker: 1,834 posts
Model Shipwrights: 41 posts
Posted: Wednesday, March 01, 2017 - 09:44 PM UTC
I have the habit of taking things apart to check if there is something useful for modelling inside.
Cables contain copper wires of various thicknesses.
When I disassembled the cable on some broken mobile phone earplugs I found that the shielding consisted of a narrow strip of thin copper foil wound around the wires inside. They were less than 1 mm wide and my thought then was that they would be ideal for safety harness belts.

Another possibility is to use thin copper wire (or aluminum if you can get hold of thin alu-wire). Fasten (tape down the ends) short pieces on a hard (steel plate) surface and flatten them by rolling a steel pipe (or other hard cylinder) along them (press hard).
Copper can be softened, if needed, by heating with a flame.
The rolling will flatten the wire and also make it slightly longer so you may need to adjust the adhesive tapes holding them down. The flattened wire will have rounded edges and be smooth so they willresemble leather straps.
/ Robin
Visit this Community
Queensland, Australia
Joined: April 23, 2015
KitMaker: 2,781 posts
Model Shipwrights: 61 posts
Posted: Wednesday, March 01, 2017 - 08:56 PM UTC
Try aluminium foil. The stuff that comes on Champagne type bottles is a bit firmer than the kitchen kind. Just make sure your knife is very sharp.

Visit this Community
Queensland, Australia
Joined: September 04, 2015
KitMaker: 671 posts
Model Shipwrights: 3 posts
Posted: Wednesday, March 01, 2017 - 04:26 PM UTC
I use the foil that seals the tins of Milo....yes the chocolate powder... ....it is thick enough to resist shear and easy to work, but in the other hand is very fine, or masking tape Tamiya.
Visit this Community
New Zealand
Joined: May 13, 2013
KitMaker: 97 posts
Model Shipwrights: 0 posts
Posted: Wednesday, March 01, 2017 - 03:08 PM UTC
Hi guys. I'm working on some US tankers WW2 1/35 and I want to make the leather straps for their helmets. I would just cut up some paper strips but the paper just frays or tears if you cut it that small. What else could I use? Do they do plastic sheet that thin?